PowerMark USB Printer Driver

9/28/06
0.02 MB, ZIP


The electronic file of the Brady PowerMark® USB Device Driver is available
for download in ZIP format.

PowerMark® USB Print Driver Installation

Step 1. Unzip the contents of the "PowerMark_USB_Driver_.zip"
file to a location that can be easily accessed in later steps

Step 2. Power down the computer and printer

Step 3. Connect USB cable (E200534) to the computer and printer

Step 4. Power up Printer first and put unit into on-line mode

Step 5. Power up computer and upon start up, a found new hardware
message should appear. Click next and follow the dialog boxes:

• Select “Search for suitable driver for my device” then click
  next


• Select floppy disk drive and click next
  
  **Note: if the USB driver has been downloaded onto the hard drive or network
  drive select the “specify a location” option


• The system should find device driver “mcf572_pm3.inf”; click
  next


• Select finish to complete the USB driver installation
  
  

Step 6. Install PowerMark print driver by inserting Printer
Driver CD and run setup.exe

• Select Install Brady print driver and click start


• Select “PoweMark” for the model of printer and click OK


• When installing on the USB port select “no” to the automatic
  port setup
  
  **Note: If this was being setup to the serial connection than the option “yes”
  would be selected.


• Select USB printer port and click OK


• Select “Yes, I want to restart my computer now” and click finish


• Installation is complete

You must have WinZip® software to view this document. You can download WinZip for free at www.winzip.com.