GlobalMark USB Device Driver

1/25/06
0.05 MB, ZIP


The electronic file of the Brady GlobalMark® USB Device Driver is available for download in ZIP format.

GlobalMark USB Print Driver Installation

Step 1. Unzip the contents of the "GM_USB_Driver_3-7-1.zip" file to a location that can be easily accessed in later steps
Step 2. Power down the computer and printer
Step 3. Connect USB cable (E200534) to the computer and printer
Step 4. Power up Printer first and put unit into on-line mode
Step 5. Power up computer and upon start up, a found new hardware message should appear. Click next and follow the dialog boxes:

• Select “Search for suitable driver for my device” then click next


• Select floppy disk drive and click next
  **Note: if the USB driver has been downloaded onto the hard drive or network drive select the “specify a location” option


• The system should find device driver “wceusbsh.inf”; click next


• Select finish to complete the USB driver installation

Step 6. Install Megellan print driver by inserting MarkWare 3.0 CD and run setup.exe

• Select Install Brady print driver and click start


• Select “Magellan” for the model of printer and click OK


• When installing on the USB port select “no” to the automatic port setup
  **Note: If this was being setup to the serial connection than the option “yes” would be selected.


• Select USB printer port and click OK


• Select “Yes, I want to restart my computer now” and click finish


• Installation is complete
  

You must have WinZip® software to view this document. You can download WinZip for free at www.winzip.com.