ToughStripe Floor Tape Applicator - How To Load

[00:00:03] - Loading the ToughStripe applicator is simple.
[00:00:07] - Unlock the cartridge using the lever.
[00:00:09] - Lift it out of the base and place it on a flat surface.
[00:00:13] - Rotate and remove the yellow tightening disc.
[00:00:16] - Push your tape roll onto the spindle with the leading edge coming from the bottom of the roll.
[00:00:22] - Turn the spindle with your hand to unroll a short length of tape.
[00:00:25] - If your tape has a liner, flip the locking bar open.
[00:00:29] - Peel back the liner from the tape and slide it under the locking bar.
[00:00:33] - Flip the liner locking bar closed and turn the tape spindle to make sure the liner is collected.
[00:00:40] - Slide the tightening disk back on and rotate until it locks, securing the tape.
[00:00:46] - Lower the cartridge back into the base and lock it.
[00:00:50] - Tack your tape into position and roll the applicator forward until it contacts the tamping wheel.
[00:00:56] - Now you can begin to lay down your tape.
[00:00:59] - Straighter lines in less time with the ToughStripe Floor Tape Applicator.